Features and Benefits


The perimeter edge metal components and/or a wind speed-specific requirement may be available in the roof system manufacturer’s full system warranty and provide additional value. Please contact your roof system manufacturer to verify and comply with all requirements of their total system warranty. 

  • - ANSI/SPRI/FM-4435 ES-1 Tested to comply with International Building Code
  • - FM Approved for wind uplift protection
  • - Miami-Dade County Approved  to comply with the High Velocity Hurricane Zone of the Florida Building Code
  • - Allows for heavier gauge materials with standard face heights
  • - Provided in 12'-0" lengths with pre-punched holes for quicker installation and lower labor costs
  • - Slotted fastening holes allow for thermal movement of the materials and ensure correct fastener placement and spacing
  • - All anchor bar EPDM splice plates, cover splice plates, and fasteners are included (sealant by others)
  • - Anchor bar can be removed, cleaned and reinstalled at any time without compromising its strength and appearance
Technical Data
  • Cover Materials: 24 ga. and 22 ga. galvanized steel,  .040", 050", and .063" aluminum (NOTE: 10" is only available in 22 ga. steel, .050" and .063" aluminum)
  • Standard sizes: 4", 5.5", 7", 8.5", and 10" for one to five nailer coverage
Face Height (in) Nailers Covered
4 1
5.5 2
7 3
8.5 4
10 5

Product Downloads

Wind Calculator

Please note that these calculations are based on U.S. measurements and roofing practices, and may not be sufficient or applicable for use outside of North America.